Due to vendor restrictions this product does not qualify for this offer.
Fitment Note: Will not work on 'Laydown" license plates.
Sold in Units: Each
looks good,just a little hard to open if needed
caps are hard to take off
love it exactly what i was looking for
The tube looks nice, but the usability is poor. The end caps are so tight, the only way to remove them is with a pair of pliers.
This mounting location and tube design are great, but the design could be improved by screw-on or bayonet lock rather thatn the o-ring friction seal. Would prefer that this was still made in USA rather than China. However, looks good and functions fine.
I'm very pleased with the product. Evry easy to install and looks great, good finish. The ends fit tightly, can only wait and see how the orings hold up. The product could have been 1/2" to 1" longer and about the size of a quarter inside dia. But that's ok, I might should have ordered the larger size? In all good product, "GREAT Service", will buy from J&P again.
Had to make slight adjustment in width for Texas plate, but looks good once mounted.
This tube is a neat document holder that looks great on my bike. The removable ends are tight and hard to open but it still works for me. Looks great as well.
Just got it, it's great! Instructions would help, but easy enough to figure out. When the mounting holes didn't match up, I cussed before I noticed the tiny set screws to loosen for adjusting the mounts. Went on easy! Keeping my registration and proof of insurance in it, but carry a swiss army knife or pliers in your bag....it's near impossible to open with your fingers.