S&S Cycle Hp103 Ge Easy Start Gear Drive Camshaft Set 2007-17 Twin Cam

S&S Hp103 Ge Easy Start Gear Drive Camshaft Set 2007-17 Twin Cam

Features

• Comes with camshafts and inner gears, this kit is designed for those who are replacing or upgrading an engine already equipped with S&S Cycle gear drive cams, and will be reusing the existing outer gears
• Installation kit 434-207 is not included but is recommended
• S&S Cycle Easy Start Gear Drive Camshaft Set is designed for the stock oil pump
• Easy Start Cams from S&S Cycle make hard starting obsolete for 1999-16 Twin Cams.
• Gear drive version
• Start any engine with a stock starter
• Save your starter and battery!
• Reliable - tested for 10,000 starts and didn't even run the battery down!
• Automatic - no buttons to push
• Camshafts that exceed the limits of the stock valve springs require the use of special high lift springs. Most S&S cams have higher lift than stock and are designed to take advantage of the extra flow of ported stock heads or S&S Super Stock heads. Due to the high lift of these cams, S&S adjustable pushrods are recommended.
• To get the best performance from a performance cam installation, a high flow intake and exhaust system is also recommended.
• Quick installation and Easy Start Cams allow stock starter to start any engine.
• Kit contains cams, gearcover gasket, cam bearings, and instructions.
• 2005-up stock valve springs will handle camshafts with lift up to 0.585". If a camshaft with higher lift is installed, high performance valve springs capable of handling a greater lift must be used. Cams with over 0.585" of lift will cause interference between the valve spring top collar and the valve seal with stock cylinder heads
• HP103 Camshafts are designed as bolt in cams for engines with 103 and stock 9.7:1 compression up to 10.5:1. Works well with stock, un-ported heads, but is great for S&S Cycle CNC ported heads. Best power in the higher rpm range, 3000-6000 rpm.
• Bolt-in cam for stock 103 engines